You are here: Main page» Magnetic Drive Rotary Vane Pumps» Rotary vane pumps VANE-MAG® MPA series» Rotary vane pump VANE-MAG® MPA 1014 (III° Range)

Rotary vane pump VANE-MAG® MPA 1014 (III° Range)

Rotary vane pump VANE-MAG® MPA 1014 (III° Range)
Rotary vane pump VANE-MAG® MPA 1014 (III° Range)

For a larger view click on the thumbnail


Technical data MPA1014-2414 (1.45 MB)

Horizontal, self-priming, single-stage, magnetic driven rotary positive displacement pump in close-coupled design made of stainless steel also according to ATEX 2014/34/EU.

MARCH VANE-MAG® MPA series pumps are rotary positive displacement pumps, magnetically driven and made of stainless steel AISI316Ti. Characteristic wise, rotary sliding vane pumps generate low volumetric flows with middle to high discharge pressures and almost no pulsation. The operating principle is based on radial sliding vanes, which are rotating in an eccentric stator. The pump housings are machined of solid block materials. The motor power is transmitted by a force-locked connection to the hydraulic part of the pumps by strong Neodynium-Permanent-Magnets. The pump is able to work without any shaft seals, which guarantees a save and maintenance-free transfer of the liquid without any leakage of corrosive, toxic and explosive fluids. Pumps for hazardous explosive areas zone 1 or 2 are available upon request.


  • Rotating positive displacement pump
  • Sliding Vane Pump
  • Metallic housing materials
  • Magnetically coupled
  • Leak-Free
  • Rugged
  • Wet self-priming
  • Dry running capable
  • Compact block design
  • Almost no pulsation
  • Middle to high discharge pressure
  • Low capacity flow rates
  • Metering capable


Performance data

Nominal flow rate:1000 l/h
Differential pressure:max. 13 bar


1.4571:max. 120°C

Available materials 

Stator, Vanes:Carbon graphite
Bearings:Carbon graphite, SiC

System pressure

1.4571:max. 16 bar
Ti Gr.5max. 100 bar

Connection on suction side 

Thread 1“ IG
Loose-type flange DN 25

Connection on discharge side 

Thread 1" IG
Loose-type flange DN 25


IEC three-phase asynchronous motor
3x230 / 400 V
1,1 - 1,5 kW / 1450 1/min